ABSTRACT
The quest for economy in asphalt production using locally available materials necessitated this research which is aimed at evaluating the suitability of Saw Dust Ash (SDA) as mineral filler in asphalt mixture.Chemical analysis, sieve analysis, specific gravity and plasticity index tests were performed on SDA. Asphalt briquettes prepared using Ordinary Portland Cement (OPC) without saw dust as filler serve as the control. SDA was used to replace the Portland cement at 0% to 100% at an interval of 10% by weight. Marshall Test was conducted on all briquettes produced with SDA and OPC. Results of tests show that increase in SDA resulted in reduction in the value of bulk density. It was also observed that the total voids in the mix increased with SDA content, while the values of stability and flow decreased with SDA. The optimum bitumen content of 6.0% was used to prepare specimens. The flow value of asphalt decreased from 2.0mm when only the cement was used as filler to 1.0mm when the cement was completely replaced with 100% SDA. Voids in mineral aggregate increased from 18.28% when 100 % cement was used as filler to 26.32% when cement was completely replaced with SDA. Based on results of tests, the use of cement partially replaced with 10% SDA at 6% bitumen content is recommended for use in asphalt production.
CHAPTER ONE
INTRODUCTION
1.1 Preamble
Continuous generation of wastes arising from industrial by-products and agricultural residue, create acute environmental problems both in terms of their treatment and disposal. The construction industry has been identified as one of the areas where the waste can be absorbed, with the majority of such materials used as filler in concrete (Antihos et al., 2005). If these fillers have pozzolanic properties, they impart technical advantages to the resulting concrete and also enable larger quantities of cement replacement to be achieved (Hossain, 2003). Approximate utilization of these materials brings ecological and economic benefits. Waste material recycling into useful products has been the current method of solving waste problems (Ahmed, 2006). Material recycling has been a common practice for most of human history with record as far back as Plato in 400 BC (Grosse, 2010). Recycling is a process to change waste materials into new products to prevent hazards associated with waste, reduces the consumption of fresh raw materials, and it also reduces greenhouse gas emissions arising from the conventional method of disposing such wastes (Grosse, 2010).
Terms of Use: This is an academic paper. Students should NOT copy our materials word to word, as we DO NOT encourage Plagiarism. Only use as a guide in developing your original research work. Thanks.
Disclaimer: All undertaking works, records, and reports posted on this website, eprojectguide.com are the property/copyright of their individual proprietors. They are for research reference/direction purposes and the works are publicly supported. Do not present another person’s work as your own to maintain a strategic distance from counterfeiting its results. Use it as a guide and not duplicate the work in exactly the same words (verbatim). eprojectguide.com is a vault of exploration works simply like academia.edu, researchgate.net, scribd.com, docsity.com, course hero, and numerous different stages where clients transfer works. The paid membership on eprojectguide.com is a method by which the site is kept up to help Open Education. In the event that you see your work posted here, and you need it to be eliminated/credited, it would be ideal if you call us on +2348064699975 or send us a mail along with the web address linked to the work, to eprojectguide@gmail.com. We will answer to and honor each solicitation. Kindly note notification it might take up to 24 – 48 hours to handle your solicitation.